-Good ROF (1.5 seconds?)
-Feels so perfect!
-no mag push
-Magazine holds 3 bullets (can make mag longer, but then you need a mag push)
-Fake barrel isn't very strong....
-3 broken parts. ( you can probably get it to work with just 2......)
Step 1: The Stock
1: What you'll make
2: Make one of each
3: Make one of the top one, and one of the bottom one
4: Put 10 blue rods on the one shown in the pic.
5: attach the plate that you made two of on to the bottom.
6: add another plate
7: Finish by adding the last plate, and add white rods and tape. Also, build the things shown in the picture.
Step 2: The Body
Get buildin' Son!
1: What you must make
2: Build the panels, Build two of the smaller one.
3: Make this junk. Read image notes.
4: Add!!! Remember that dark grey connector ;)
5: Add s'more. Remember EVERYTHING!
6: Add the rest of the plates.
7: Make everything in the pic.
8: Add 1 plate.
9: Add the next.
10: add the last two, and put white rods where shown. Make piece thingy in the pic too.
11: put the thingy on, and add two green connectors :)
Step 5: Let's Build! Plus bandingt
Let's build. This gun is kinda tricky to put together.
1: Blurrry! Well, get your stock, and the body. Put all the parts on the body.
2: Put that pin guide on the stock first, Then add that bendy handle and put a white rod with tape on it. Make sense?
3: Turn it over. Add that part you made earlier, and add two white rods. I don't know if tape is necessary. Read notes.
4: close up of the attachment here.