loading
Picture of Knex Pistol
IMG_0325.JPG
IMG_0326.JPG
I was throwing random k'nex pieces together when I made something that looked kind of like a body for a gun, and then I had a pistol. Now about the pro's and con's...

Pro's:
Looks good
True Trigger
Comfy handle

Con's
Single shot
Not good for long range shots (Shoot 25-35 ft.)
 
Remove these adsRemove these ads by Signing Up

Step 1: The body

Picture of The body
IMG_0329.JPG
IMG_0330.JPG
IMG_0346.JPG
IMG_0332.JPG
IMG_0334.JPG
This is the hardest step, but it's pretty easy. Just follow pics and READ ALL IMAGE NOTES or your gun won't work.

Step 2: Trigger

Picture of Trigger
IMG_0337.JPG
IMG_0338.JPG
IMG_0339.JPG
This piece is necessary to the gun. Once again, READ ALL IMAGE NOTES!

Step 3: Panels

Picture of Panels
IMG_0345.JPG
IMG_0347.JPG
IMG_0348.JPG

You're almost done. Just add on these panles and read all the image notes.

Step 4: Ramrod and Rubber Bands

Picture of Ramrod and Rubber Bands
IMG_0351.JPG
IMG_0353.JPG
IMG_0352.JPG
This is my version of your gun, I changed the trigger to a more reliable design and added an 8 shot mag
photo-2013-08-25 7:59 PM.jpg
joejoe9133 years ago
your trigger sucks
jnguyen53 years ago
i made mine go 55 ft
mine went through a card board box and the rod wasnt sharpened, awesome gun.
FlutterTree (author)  jnguyen53 years ago
Thanks, mine didn't go very far but probably because my elastics were bad.
Dawson.J4 years ago
it looks like you can mod it so there is a clip in the handle. (if so please try)
FlutterTree (author)  Dawson.J4 years ago
I'll try that and see if it works.
TheKnexNoob4 years ago
nice, might make this later
automan974 years ago
im new wat is that on the end of the ram
FlutterTree (author)  automan974 years ago
That's a ball joint connector covered in electrical tape. If you don't have one than you can cut an orange connector in half
jamesdude5 years ago
not bad.... 1st comment!
FlutterTree (author)  jamesdude5 years ago
Thanks.
~KGB~5 years ago
been done b4