Introduction: Knex Pistol (no Rubber Bands)

Picture of Knex Pistol (no Rubber Bands)

A working knex pistol without rubber bands.
-Unlike other guns, it doesn't use ruberbands!
-Has a clip.
-Short ranged, can only shoot about 2 feet.

Step 1: Step 1

Picture of Step 1

Gather these pieces:
6 red
1 light gray
1 green
6 dark gray
1 white
2 yellow
2 green
2 white
1 blue
3 yellow
Then assemble the clip and trigger.

Step 2: Step 2

Picture of Step 2

Assemble the following for the handle:

Step 3: Step 3

Picture of Step 3

Insert the trigger and put the two handle pieces together.

Step 4: Step 4

Picture of Step 4

Use a white rod to hold the handle together and a yellow rod for the barrel. Load the clip and fire! Move the clip to reload.


legoman111 (author)2012-11-28

Can you please explain how to assemble the clip and trigger?

charge11595 (author)legoman1112012-11-28

I'm not too proud of this one, and its been so long since I made it anyway. . .
If I remember correctly, theres nothing special about the clip or trigger. The trigger is the green connector with the other pieces attached to it. The clip is a blue rod with dark gray connectors on it. If you want to try a better gun that, you could try the one I posted a month later (link below).  I've gotten better with instructions since then.

Whaleman (author)2009-09-03

How is a lack of rubber bands a pro if it causes it to shoot 1/20 of what it should?

charge11595 (author)Whaleman2009-09-04

This knex gun is probably the first gun that doesn't use rubber bands.

Whaleman (author)charge115952009-09-04

So... that's good how?

charge11595 (author)Whaleman2009-09-05

Did you even build one and try it out?
If you don't like it, disassemble it!
I have another gun that doesn't use rubber bands too, but it is a lot better.

lowe (author)charge115952010-12-04

what is the clip part?

KnEx_MaStEr (author)2010-08-18


About This Instructable




More by charge11595:Knex RBG: FN P90 ReplicaComputer Mouse Button TransplantDIY E14 to E12 Light bulb adapter from a E14 lightbulb
Add instructable to: