Instructables
Picture of Knex Sawn-off Shotgun - The Bonecrusher
Back end.jpg
Ram rods.jpg
Handle and triggers.jpg
Front end.jpg
Grip.jpg
Long view.jpg

So I was playing GTA: TLAD and I kinda fell in love with the sawn off shotgun, so I built this
Pros
-Really good range
-Accurate
-Double barrel
-Barrels can be fired individually
-Two true triggers
-Grip
-Looks... really nice
-Can fire any type of rod
..
Cons
-can only hold two shots
-Its a huge drain on parts

Oh yes I can see the huge drain on parts. This clearly uses an un-comprehendable amount of parts. Bravo.
Do I detect a hint of sarcasm?
Bit.
Considering the ratio of parts to size this does use a lot of parts.
DJ Radio3 years ago
2 true triggers=fail
The Chunky Sniper! (author)  DJ Radio3 years ago
What?
but i dont understand it either :)
The Chunky Sniper! (author)  DJ Radio3 years ago
I'll repeat,what?
he said "two triggers EQUALS fail"
I like the name!
post please
Sorry, I broke this up ages ago.
~KGB~3 years ago
its ok
The Chunky Sniper! (author)  ~KGB~3 years ago
Thanks man. (It actually works reallly well, if I had a decent camera I would upload instructions and you lot would really like it)
nice =D
Seleziona3 years ago
(removed by author or community request)
The Chunky Sniper! (author)  Seleziona3 years ago
Cool I'll check that out. I'm still learning new mechs etc, this was mainly an experiment to see how well a double barreled gun would work. As it turns out - very well.
Yes, they do tend to work quite well. If I could say something else, I would tell you to make the rubberbands to pull the pin from each side equally, not just attached on one side of the pin so the firing pin breaks.
The Chunky Sniper! (author)  Seleziona3 years ago
Agreed.