Remove these ads by
Flag this comment as:
Not NiceInappropriateSpam
3 Simple Ways to Share What You Make
With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
Create on the go:
With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
Hello there,I made a knex lightsword design. Due interest I decided to post instructions for this. Its the first instructable that I have made, so if ...
Follow pictures:Put the two gears on the small black rod, and place it between the two large rods.
Follow pictures.
Now you add two black rods.- Slide all parts to one side.- Connect the black rods to the black snowflake and gray 3-connectors.- Slide those to the le...
Follow Pictures.Picture 2/3/4/5connect a gray 1-connector + small black rod to the black snowflake, with the gray connector holding the gears in place...
For this part you need the "red knex man hand" like the ones shown in the first picture. And make the parts in the second picture.Put them on the ends...
Ok, now you need to take the parts made in step 4 and put the rubber band on it as shown in picture 2 and 3. Then connect the parts to the handle. You...
Take a small and wide wheel, put a small black rod on it (not shown on the picture). Then slide the tire off the rim just a bit, so it will fit around...
I did the yellow laser with yellow rods and connectors. Just snap some together, but make sure that you keep two rods sticking out on one end so you c...
Here's some other variations that i made.I put a white blade on it. and replaced the two gray (yellow size) rods and the two pieces that are on the ge...
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »