Introduction: Knex Tomahawk

Picture of Knex Tomahawk

My knex Tomahawk is here and is very good. i thought it will be nice to make a tomahawk for all knex + zombie killing lovers.So get your knex out and start building!



PROS:very good, uses little pieces,great for a zombie killer


CONS,if hit blade on a hard surface blade will break,wobbles.


Step 1: Parts List

Picture of Parts List

NOTE:LOOK AT THE PICTURES TO SEE PARTS LIST!

Step 2: The Insides,Handle,Stem

Picture of The Insides,Handle,Stem

pic 1=The inside. (from left to right)= orange connector,blue rod,white connector,tan clip,2 blue spacers,tan clip,White connector,2 blue spacers,orange connector,white rod,orange connector,white rod,white connector,Tan clip
pic 2= add the rods to make handle(cover with 8 rods).
pic 3=Make the stem (cover with 6 rods. leave two across from each other)

Step 3: The Blade

Picture of The Blade

pic 1=make the blade
pic 2= save 2 orange flexi rods for later

Step 4: Assembly

Picture of Assembly

pic 1=connect the blade
pic 2=connect the orange flexi rods.
pic 3= connect the orange fexi to the whit

Step 5: Finished

Picture of Finished

YOU ARE FINISHED HOORAY!!!!!!!!!!!!!!!

Comments

knexboy586 (author)2012-06-01

there is a improved one it does not wobble

sniper_lover (author)knexboy5862012-09-02

minee ;D

knexboy586 (author)sniper_lover2012-09-03

i like yours its cool

sniper_lover (author)2012-07-20

Maybe you could make the blade à little smaller, but further iets nice

TheAwesomestDude (author)2012-06-01

its good

About This Instructable

635views

1favorite

License:

Bio: [<>_<>] he is wacthing you
More by knexboy586:Knex RBG The StingerThe Brusier Knex Gun V.2Knex Flail
Add instructable to: