Instructables

Step 6: EXTRAS:

Picture of EXTRAS:
Picture 213.jpg
Picture 212.jpg
Picture 214.jpg
Picture 215.jpg
Picture 216.jpg
Picture 217.jpg
Picture 218.jpg
This step is a scope and bi-pod addition. (This is not required.)

1 This is the mounted scope.
2 Build the scope as shown. You aim by looking through the gray connectors' holes.
3 This is the mounted bi-pod.
4 and 5 Build this.
6 Connect the two halves and add blue rods where shown.
7 Attach the Black Y connectors to each side if you are on the carpet. For stick in the carpet and keep the stock from sliding.
8 Finally attach the stock to the mount underneath the barrel.\

Now you are done. Thank You. :D
 
Remove these adsRemove these ads by Signing Up