Introduction: K'nex Frag Grenade (based Off Idea by the Inventor)

Picture of K'nex Frag Grenade (based Off Idea by the Inventor)

this k'nex frag grenade is based off an idea by the inventor. the link to his grenade can be found here:

the only parts that detatch on impact are the red pieces. the rest of the grenade stays intact, making it easy to rebuild.

Step 1: Materials

Picture of Materials

you will need:
2x small green rods (NOT PICTURED)
10x red connectors
2x blue connectors
1x blue rod
2x white "snowflake" connectors

Step 2: The Basics

Picture of The Basics

attatch the two blue connectors to make a ball.

also, attatch a green rod to each white connector.

Step 3: Add the Fragments

Picture of Add the Fragments

add the red connectors to the white connectors, as pictured.

no rods should be used to connect the red pieces.

Step 4: Putting It Together

Picture of Putting It Together

first, attatch everything as pictured.

then, simply attatch the blue rod as pictured. this will act as a handle you can use to throw.

Step 5: Throw It

have fun with this! tell me where i could improve, and give me feedback


kinexmaster2000 (author)2011-06-26


thorncastle (author)2011-03-03

could u add a third white bit at the top 4 more shrapnel?

zxzxxzxxzxxzx (author)2010-08-12

it dosn't work

Chromatica (author)2009-12-13

Clever idea.

About This Instructable




Bio: I'm josh, i skate, and like to have fun. i'm 14, in 9th grade, and also like to play call of duty world ... More »
More by FeebleReaper:Easy, Affordable, Play Dough!K'nex frag grenade (based off idea by the inventor)
Add instructable to: