Print PDF
Favorite
Email
Step 7Assembley
I find assembling you knex items to be the funnest step. Time to watch your lift take shape!
1: All the pieces you should have
2: Start by putting the wheel over the axle on the base #2
3: Then put a tan clip on the grey rod and push it into the white connector
4: Then put spacers on as shown
5: Put base #1 on top
6: Make the grey rod go through the white connector on base #1
7: Put a blue spacer on the end and cap it off with a tan clip
8: Now that it can stand upright, make it do so
9: Put the ball dispenser on as shown
10: Just so you can see that connection
11: Put the ball receiver on as shown
12: Connect those yellow rods!
13: And the grey ones
14: Assembled Ball lift :-)
1: All the pieces you should have
2: Start by putting the wheel over the axle on the base #2
3: Then put a tan clip on the grey rod and push it into the white connector
4: Then put spacers on as shown
5: Put base #1 on top
6: Make the grey rod go through the white connector on base #1
7: Put a blue spacer on the end and cap it off with a tan clip
8: Now that it can stand upright, make it do so
9: Put the ball dispenser on as shown
10: Just so you can see that connection
11: Put the ball receiver on as shown
12: Connect those yellow rods!
13: And the grey ones
14: Assembled Ball lift :-)
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
