Knex Auto Loading gun with magazine.

This is my first working knex gun that actually has a mag. the magazine is built for yellow, and i don't think you can build it to fit any other bullet....i ran into some complications along the way because pieces were not cooperating...that is why a few of the steps look funky.

Remove these ads by Signing Up

Step 1: The Magazine

1.you will need 4 of these.

2.Take two of those pieces you just made, and connect them together using small green/black rods. you will need two of these.

3.connect the two pieces with two reds connected with a blue rod, use small green rods to connect to pieces.

4.attach a yellow connector to the bottom of each yellow piece, two on each side. connect with green rods

5. you will need two of these (the orange piece should not be broken, i just ran out of pieces)

6. connect the pieces as shown, NOTE*the orange connector should only be attached to one of the white/black rods,then placed into the other blue one. (again, the orange connector should not be broken)

7. you will need 4 of these wierd black connector/rod.connect one at the end of each yellow connector

8. now attach a blue rod to the side of the two black things, but be sure to place a green connector through it first, do this on both sides, but make sure the green connectors are facing as shown.

9. you will need 4 of these wierd black connector/rod.connect one at the end of each yellow connector
now attach a blue rod to the side of the two black things, but be sure to place a green connector through it first, do this on both sides, but make sure the green connectors are facing as shown.

10. now attach a blue rod to the side of the two black things, but be sure to place a green connector through it first, do this on both sides, but make sure the green connectors are facing as shown.