Introduction: Knex Tavor TAR-21

Picture of Knex Tavor TAR-21

Bolt action
The trigger jams every once and a while but its an easy fix.

**** instructable at https://www.instructables.com/id/Knex_Tavor_TAR_21_Instructable/

Comments

carrothead23 (author)2009-05-16

go israli guns tavor rules

knexsniper1 (author)2009-04-14

what is bolt action?

barrax (author)knexsniper12009-04-15

pull a bolt back, then push it foward again, to load each shot. in most guns you twist as well.

knexsniper1 (author)barrax2009-04-15

oh, that can easily be done for a gun with the mag on the top. by mag i mean hopper. not so easy with a mag on the bottom because when you push the bullet back, another one will just go into place and it will block the other one.

barrax (author)knexsniper12009-04-16

it has been done on the top (see jollex's B.A.G.) with bottom feeder. it's a little different

knexsniper1 (author)barrax2009-04-16

ok, for a bottom fedder, you sort of can't have a mag cause the bullet will be blocked by another one.

barrax (author)2009-04-14

real bolt action?

maxxxem (author)barrax2009-04-15

i guess yes

barrax (author)maxxxem2009-04-15

i guess? do you have to pull it back THEN push it foward for it to work?

maxxxem (author)barrax2009-04-15

no its rubber banded to pull forward for you
see instructable
https://www.instructables.com/id/Knex_Tavor_TAR_21_Instructable/

knexking123 (author)2009-04-01

the gun is pretty nice but the front needs some work

ILIKEPIE333 (author)2009-01-13

POST IT!!!!!!!!!!

maxxxem (author)ILIKEPIE3332009-02-19

i did

ILIKEPIE333 (author)maxxxem2009-02-19

thanks

Oompa-Loompa (author)2008-12-30

The back looks so cool!!! Why did you give up on the front?

maxxxem (author)Oompa-Loompa2008-12-31

no pieces... missing green rods in lost of places

Oompa-Loompa (author)maxxxem2008-12-31

Aah, ok.

knex artillery (author)2008-12-30

very nicely done!

knexfan9182 (author)2008-12-30

is the tar a pdw?

knexsuperbuilderfreak (author)2008-12-30

sweet

fobblewabble (author)2008-12-29

Make the blue connector next to the trigger a white and then stick the trigger in the middle hole.

maxxxem (author)fobblewabble2008-12-29

the long rod is attached to the gery conector, the only problem is that the long rod is out side of the gun (see picture 3)

About This Instructable

2,477views

1favorite

License:

More by maxxxem:Knex FamasMore Efficient Bullpup SidearmNerf Recon/LS ammo holder
Add instructable to: