Knex Tripod

2,064

1

18

Published

Introduction: Knex Tripod

About: I'm an inactive K'nexer, I used to be one of the most active ones, but I have a lot of other things to do. I try to post a new instructables every few months, but sometimes it takes a while for me to think o...

Basicly, I took my knex music stand, took off the holder, made it taller, and Modded the Hell out of it.

Here it was,
Right here
Enjoy!

Step 1: Follow Instructions

Take off top (of music stand) And then build pic 2.

Step 2: Do This.

get a 1 inch long quarter inch bolt, put through 1 white, clip on blue, add 2 whites, stick yellow rod down middle, add grey clip to yellow, add white connector and 4 greens.

Too many pics.

Step 3: Connect

Done!

Share

    Recommendations

    • Planter Challenge

      Planter Challenge
    • Casting Contest

      Casting Contest
    • Clocks Contest

      Clocks Contest
    user

    We have a be nice policy.
    Please be positive and constructive.

    Tips

    Questions

    18 Comments

    I know. I kept the name as tripod because more people are likely to search "tripod" than "monopod", and it does essentially the same thing.

    Not as is, but you could easily change it.

    I meant, is it sturdy enough to support a rb2 mic, I tried a stand and it failed.

    If you're not going to tell people how to make the music stand, you could at least include a link to those instructions.

    Oh, and you should have made two of these stands.

    Then maybe the photos would have been in focus...

    3 replies

    I used a webcam

    right you are!

    Why you little!

    this is not a tripod, it is a monopod, or maybe a quadropod on a flat surface

    actually, it is a quadro-pod, but a tripod is in general anything you screw a camera on to.

    no, it's not a quadro-pod because the legs are connected. and a tri-pod has to have 3 legs coming out. cameras only use tri-pods because no matter what all three legs will touch the ground.

    Whatever im still keeping it as tripod.

    it isn't and-pod actually. more of a mount... if it was actually solid.

    well, ya, thats mostly what i meant.

    its a mono pod... and this isn't really even an instructable...