Knex UMP-45

Step 4 Stock

Pretty simple step. Like I said earlier this uses a full stock instead of a realistic (well for the UMP I think this looks realistic in general) stock. Turns out I'm not half bad at making them. It's pretty sturdy and it does its job. Unfortunately the firing pin goes over the top of it so you'll have to rest your cheek on the very back to use the sights. Sorry I didn't break it up more but I figured you would be able to figure it out without too much problem.

1-2 Here is most of the stock. They are exactly the same with only two layers being 5 layers apart connected by a series of orange and yellow connectors. Here is also view of the back
3. Connect to the back of the gun like so.
4-6. This is the top of the stock. Credits go to Mepain for this part from his sniper. I used this only to make the top flat without using a lot of connectors but you can use grey rods if you want to. Notice that only one side connects fully while at the back it only slides into the very end of the slots. Don't worry it will hold there steady.
7-8. Oh yeah I forgot about the foregrip attachment. Uh pretty simple to make and add. It doesn't connect unto the rails you slide it in seeing how it's four layers rod to rod while the rail connections are separated three rails apart so the rods will go around the slots. It should stay in firmly unless you push or pull on it.