Knex Gatling Shotgun V1

This instructable shows how to make my knex gatling shotgun V1 this is the first full auto shotgun in knex history!!! credits: oblitivius cs2 shotgun barrels. ups:low parts usage 8 barrel's 24 shots powerful(usaully gets about 60 feet)more likely to hit target downs:fairly long loading time.parts list:
spacers
blue:2
silver:12
motors
blue motor:1
connectors:
tan clips:2
blue clips:2
yellow conectors:56
red conectors:19
orange connectors:18
grey connectors:8
purple 3-d connector:12
blue 3-d connector:3
white connector:4
rods
grey:11
red:9
yellow:9
blue:16
white:24
green:11

misc

64# rubber bands:16

Step 1: The Wheel

this step shows how to make the wheel.

Step 2: The Axle

This step shows how to make the axle for the wheel to spin on

Step 3: Rams

This step shows how to make the rams

Step 4: Axle

This step shows how to make the Axle and attach it to the wheel.

Step 5: Trigger Flipper

this step shows how to make the trigger flipper.

Step 6: The Base

this step shows how to make the base and connecting the axle to the motor mount

Step 7: Putting the Trigger Flipper On

this step shows how to put the triger flipper on

Step 8: Ammunition

this step shows the ammo

Step 9: Rubber Bands

This step shows the rubberbands you will need

Step 10: Loading ,cocking, and Putting Rubber Bands On

this step shows how to load ,cock,and put the rubber bands on

Step 11: Shooting

cock, load and push the motors switch toward you