Instructables
loading
loading
Picture of Knex gatling Shotgun V1
Picture 119.jpg
This instructable shows how to make my knex gatling shotgun V1 this is the first full auto shotgun in knex history!!! credits: oblitivius cs2 shotgun barrels. ups:low parts usage 8 barrel's 24 shots powerful(usaully gets about 60 feet)more likely to hit target downs:fairly long loading time.parts list:
spacers
blue:2
silver:12

motors
blue motor:1

connectors:
tan clips:2
blue clips:2
yellow conectors:56
red conectors:19
orange connectors:18
grey connectors:8
purple 3-d connector:12
blue 3-d connector:3
white connector:4

rods
grey:11
red:9
yellow:9
blue:16
white:24
green:11


misc

64# rubber bands:16
 
Remove these adsRemove these ads by Signing Up

Step 1: The Wheel

this step shows how to make the wheel.

Step 2: The axle

Picture of The axle
This step shows how to make the axle for the wheel to spin on

Step 3: Rams

Picture of Rams
Picture 142.jpg
This step shows how to make the rams

Step 4: Axle

Picture of Axle
Picture 133.jpg
This step shows how to make the Axle and attach it to the wheel.

Step 5: Trigger flipper

Picture of trigger flipper
this step shows how to make the trigger flipper.

Step 6: The base

Picture of the base
Picture 136.jpg
Picture 137.jpg
Picture 138.jpg
Picture 139.jpg
this step shows how to make the base and connecting the axle to the motor mount

Step 7: Putting the trigger flipper on

Picture of putting the trigger flipper on
this step shows how to put the triger flipper on

Step 8: Ammunition

Picture of Ammunition
this step shows the ammo

Step 9: Rubber bands

Picture of Rubber bands
This step shows the rubberbands you will need

Step 10: Loading ,cocking, and putting rubber bands on

Picture of loading ,cocking, and putting rubber bands on
Picture 144.jpg
picture 147.jpg
Picture 148.jpg
this step shows how to load ,cock,and put the rubber bands on

Step 11: Shooting

cock, load and push the motors switch toward you