Print PDF
Favorite
Email
Step 24Build Your Own Step 9 - Bare Board Version
Here is the finished scope as a "bare board" version. I added standoffs and board-mount BNC connectors.
The BNC connectors allow to connect standard 1:1 scope probes or coaxial grabber cable (see next page), while alternatively we can connect wires using the screw terminals. Similar for the power connector, here you can choose between a standard 2.1mm power plug (common on many wall-wart type power supplies) and a wire connection (e.g. if you get the power from a breadboard setup).
The BNC connectors allow to connect standard 1:1 scope probes or coaxial grabber cable (see next page), while alternatively we can connect wires using the screw terminals. Similar for the power connector, here you can choose between a standard 2.1mm power plug (common on many wall-wart type power supplies) and a wire connection (e.g. if you get the power from a breadboard setup).
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
