Print PDF
Favorite
Email
Step 8Solder Battery Snap.
Attach the battery snap to the nine volt, and check to see which wire goes with which side(positive or negative). Your belt should light up. If it doesn't, go back and make sure that no wires are touching. Then punch another hole in your belt, which will allow the wires to go through the front to the back. this should be about six inches away from the buckle. If the battery snap wires are too short, extend them. Stick the wires through the belt so that the snap is on the front, and the wires are on the back. Solder the aproppriate ends to the chain of LED's. Tape the Battery on the front so that it reaches the snap.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
Aug 7, 2009. 7:06 AMJAGleason11
says:
I added a small switch so I could turn the lights on and off it is really easy and is also you can use it to impress some one with the "Grand Lighting of your Pants". LOL.
Reply
 |
Add Comment
|
