Print PDF
Favorite
Email
Step 4Create a contact point for our switch
Alright this next part took me a while to figure out because I wanted to make it all self contained so I came up with this.
Take the metal shield and put a small bend in the bottom of it like shown in the picture, this bend will create our contact point for our switch later
You may want to use 2 pairs of pliers for this to make it easier but I was able to get the job done with one.
Take the metal shield and put a small bend in the bottom of it like shown in the picture, this bend will create our contact point for our switch later
You may want to use 2 pairs of pliers for this to make it easier but I was able to get the job done with one.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
