loading

Make a fun, glowing LED-Follower which looks amazing. Super easy project for all ages.

Step 1: Materials

An Arduino Uno

Bread Board

Jump Wires

LED's

USB Data cable

Step 2: Connections

Connect all the negative terminal of the LED's to ground on the Arduino. Connect the individual positive terminals to each digital pin holder on the Arduino.

Step 3: Re-check

Re-check all the connections. Connect the data cable to the Arduino and start typing the codes. Assign the positive terminals as digitalWrite for all the LED's and set a delay time between them . Upload the codes to the board.

Step 4: Power Up!

Connect the USB cable and enjoy the lighting.

<p>Cool project. Could you include a copy of the code.</p>
<p>void setup() {</p><p> pinMode(0,OUTPUT);</p><p> pinMode(1,OUTPUT);</p><p> pinMode(2,OUTPUT);</p><p> pinMode(3,OUTPUT);</p><p> pinMode(4,OUTPUT);</p><p> pinMode(5,OUTPUT);</p><p> pinMode(6,OUTPUT);</p><p> pinMode(7,OUTPUT);</p><p> pinMode(8,OUTPUT);</p><p> pinMode(9,OUTPUT);</p><p> pinMode(10,OUTPUT);</p><p> pinMode(11,OUTPUT);</p><p>}</p><p>void loop() {</p><p> digitalWrite(0, HIGH);</p><p> delay(50);</p><p> digitalWrite(0,LOW);</p><p> digitalWrite(1, HIGH);</p><p> delay(50); </p><p> digitalWrite(1,LOW);</p><p> digitalWrite(2, HIGH);</p><p> delay(50); </p><p> digitalWrite(2,LOW);</p><p> digitalWrite(3, HIGH);</p><p> delay(50); </p><p> digitalWrite(3,LOW);</p><p> digitalWrite(4, HIGH);</p><p> delay(50); </p><p> digitalWrite(4,LOW);</p><p> digitalWrite(5, HIGH);</p><p> delay(50); </p><p> digitalWrite(5,LOW);</p><p> digitalWrite(6, HIGH);</p><p> delay(50); </p><p> digitalWrite(6,LOW);</p><p> digitalWrite(7, HIGH);</p><p> delay(50); </p><p> digitalWrite(7,LOW);</p><p> digitalWrite(8, HIGH);</p><p> delay(50); </p><p> digitalWrite(8,LOW);</p><p> digitalWrite(9, HIGH);</p><p> delay(50); </p><p> digitalWrite(9,LOW);</p><p> digitalWrite(10, HIGH);</p><p> delay(50); </p><p> digitalWrite(10, LOW);</p><p> digitalWrite(11, HIGH);</p><p> delay(50); </p><p> digitalWrite(11,LOW);</p><p>}</p>
Thanks
<p>Yeah</p>

About This Instructable

746views

9favorites

License:

Bio: I'm an engineering student passionate about Creativeness coding!
More by thisisrammy:Electro-Luminescent T-Shirt Radio Frequency controlled LED Spark Lights 
Add instructable to: