Print PDF
Favorite
Email
Step 10Prepare the Hat's Display Hole
This is the first step in installing the electronics in your hat.
Start by tracing a template of the display and cut it out. Tape the cut-out to the hat where you want the display to go, then trace it with the hobby knife. Be vary careful at this part, it is easy to slip when cutting hard curved surfaces. Now with the outline on the hat, take the plastic cutting knife and trace along the lines until you poke through. Now finish the hole by cutting out the remaining joining plastic with the hobby knife.
Start by tracing a template of the display and cut it out. Tape the cut-out to the hat where you want the display to go, then trace it with the hobby knife. Be vary careful at this part, it is easy to slip when cutting hard curved surfaces. Now with the outline on the hat, take the plastic cutting knife and trace along the lines until you poke through. Now finish the hole by cutting out the remaining joining plastic with the hobby knife.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
