Introduction: LED Jack O Lantern

Picture of LED Jack O Lantern

This is a low-cost diy Led lantern.
It's very easy to make.

Step 1: What Do You Need?

Picture of What Do You Need?

You will need:

1x pumpkin
1x knife
1x soldering machine
1x(or more) LED
1x(or same ammount of leds) resistor
1x isolation tape
1x solder
1x pen 
1x permanent marker
1x battery holder

Step 2: Drawing Your Model.

Picture of Drawing Your Model.

Draw your own sketch on a paper.

Step 3: Prepare the Pumpkin's Inside

Picture of Prepare the Pumpkin's Inside

1. Draw a rectangle on the uglier side of your pumpkin.
2. Take out the rectangle.
3. Clean the inside.

Step 4: Draw It With Permanent Marker

Picture of Draw It With Permanent Marker

Step 5: Making the Shape

Picture of Making the Shape

With your knife srcape the pumpkin.

Step 6: Add Electronics

Picture of Add Electronics

Sold it together and add it to the pumpkin.


Picture of OPTIONAL

Optionally you can make a back, for the pumpkin.


About This Instructable




More by Adamman:Diy gingerbread houseMinecraft Steve head cardboardLED Bank lamp
Add instructable to: