Print PDF
Favorite
Email
Step 5Solder!
This step is straightforward because you'll made all the connections mechanically. Make sure the LEDs are in their holes and are sitting level and not askew. I admit I wasn't able to get all the LEDs to sit perfectly straight through the holes - it still works well, but I figure they would have been even worse if I hadn't gotten everything laying flat before I soldered.
If you've never soldered, take a look at the [http://www.instructables.com/id/How-to-solder// How to Solder] Instructable.
Solder every mechanical connection you've made.
Wrap electrical tape around the wire-to-wire connections - this will be the connections to the battery snap connector and any patches you've made on the long red and black wires.
If you've never soldered, take a look at the [http://www.instructables.com/id/How-to-solder// How to Solder] Instructable.
Solder every mechanical connection you've made.
Wrap electrical tape around the wire-to-wire connections - this will be the connections to the battery snap connector and any patches you've made on the long red and black wires.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
