With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
This is a series of Paper Craft Lamps that use LED's. I modeled up a lamp in Blender, and then assigned textures to each of the parts, so if you want ...
Gather the materials needed.These are needed for sure*Rubber Cement*Hot glue/Gun*Double sided tape*x-acto knife / razor*4-LEDs (use High-Output or Ult...
You can use these links to download one or all of the lamps that I have made. lamp1 lamp2 lamp3 lamp4 lamp5 lamp6 lamp7 lamp8all lampsOR you c...
These are the cut and fold instructions for the lamps. Each tab number is matched to an edge number. The dotted lines indicate folds, and the solid li...
These are the parts that have been cut out and assembled. This process is really straight forward, just follow the instructions included in the downlo...
The LEDs are glued to the front side of this square, and wires and resistors are placed onto the back of this part.
Connect you chosen power source and test that every thing is working. LEDs are directional so if it is not working try switching the leads.
Cut the holes to run the wires, and fit the switch in.
Wire the Switch in.
Glue the stem on and thread the wires through.
This step is where the top is joined into place.
This is the final step, just put the shade on, and straighten. Then give it a try.
Remove these ads by
Signing Up
Not NiceInappropriateSpam
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »