loading
Picture of LED Ping Pong Ball (Improved)
This is basically the same design, but I made it more neater and it looks much better!!

This is the old: http://www.instructables.com/id/LED-Ball/
 
Remove these adsRemove these ads by Signing Up

Step 1: Tools

Picture of Tools
pingponged (14).jpg
pingponged (12).jpg
pingponged (4).jpg
You will need the following:

1. Drill

2. Drill Bits

3. Scissors

4. Duct Tape

Step 2: Materials

Picture of Materials
pingponged (8).jpg
pingponged (26).jpg
You will need the following:

1. LED Throwie (This is the link: http://www.instructables.com/id/LED-Throwies/)

2. Ping Pong Ball

3. Two Water Ballons or One Normal Balloon

Step 3: Make Hole in Ping Pong Ball

Picture of Make Hole in Ping Pong Ball
pingponged (17).jpg
1. Drill Hole in ball.

2. Keep on drilling until it reaches the size in the photo below.

Step 4: Cut It Bigger

Picture of Cut It Bigger
pingponged (25).jpg
1. Get scissors and cut hole in ping pong ball to fit throwie.
-Bend throwie to make smallest hole you can without breaking ball and without making hole too big.

2. Put throwie inside of hole.

Step 5: Balloon Time!

Picture of Balloon Time!
pingponged (25).jpg
pingponged (28).jpg
pingponged (29).jpg
1. Get a water balloon and get off the top area. inside picture below.

2. Wrap balloon around ball. See picture below. Make sure to cover up hole while doing it.

3. Repeat step 2 so no part of ping pong ball is showing.

Step 6: Complete!!!!

Picture of Complete!!!!
Enjoy it and tell me how to make it better....