Introduction: LEGO 1st Gen Ipod Shuffle Dock

Picture of LEGO 1st Gen Ipod Shuffle Dock

An IPod shuffle dock i made out of LEGO when i was bored and was annoyed with my ipod sitting arround on the desk. My First instructable so go easy. If any one has any ideas on howican improve please let me know.

Step 1: Step 1

Picture of Step 1

Attach the bottom bricks but leave a gap through the centre to fit the cord.

Step 2: Step 2

Picture of Step 2

Put the cord in place and attach the layer of bricks shown.

Step 3: Step 3

Picture of Step 3

Attach another layer as shown

Step 4: Step 4

Picture of Step 4

Now add another layer.

Step 5: Step 5

Picture of Step 5

Now Make this piece

Step 6: Step 6

Picture of Step 6

And attach it to the base like so in the picture.

Step 7: Step 7

Picture of Step 7

Now make two of this piece.

Step 8: Step 8

Picture of Step 8

And attach them like this.

Step 9: Finish

Picture of Finish

Plug in your ipod shuffle first gen and plug the dock into the computer and your away!!!

Comments

About This Instructable

1,408views

0favorites

License:

More by skatelong:Thumb Wrestling Ring.Secretley watch ipod movies at school.Speakil case
Add instructable to: