Step 4: Positioning the Face.
I've noticed that on the forming tubes there are ridges where cardboard meet together. Find a smooth side to work on for best results.
The bottom of the smile is located roughly 2.5" from the bottom, but the length of your head could alter the look, so do your best to center the face on the head. Now tape the copy paper to the face, making sure its level and prepare for surgery!
The way I took was use the X-acto knife to cut the eyes and smile out of the forming tube. This takes awhile and there may be other ways to do this if you have the right tools. Take your time, any mistake and you might have a LEGO man scar on your hands.Cut the face out slightly smaller than what is drawn, when you sand it later to smooth it out it will remove the extra cardboard.
The bottom of the smile is located roughly 2.5" from the bottom, but the length of your head could alter the look, so do your best to center the face on the head. Now tape the copy paper to the face, making sure its level and prepare for surgery!
The way I took was use the X-acto knife to cut the eyes and smile out of the forming tube. This takes awhile and there may be other ways to do this if you have the right tools. Take your time, any mistake and you might have a LEGO man scar on your hands.Cut the face out slightly smaller than what is drawn, when you sand it later to smooth it out it will remove the extra cardboard.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
Visit Our Store »
Go Pro Today »
