Print PDF
Favorite
Email
Step 2Warm up your soldering iron!
There is quite a bit of soldering for you to do in the next 30-45 minutes. After warming up your soldering iron and tinning the tip, you need to get the circuit board and the components and parts out on a workbench or desk where you solder. The image below has notes on where to place the parts.
Just a little note to you who are first-timers when it comes to soldering. In order for the jumper wires to stay in place when the board is flipped over, slightly bend the leads outward so it is stable. Note the bolded word: slightly. Do not bend them too much, or else it is difficult to trim the leads, causing a risk of a short.
Just a little note to you who are first-timers when it comes to soldering. In order for the jumper wires to stay in place when the board is flipped over, slightly bend the leads outward so it is stable. Note the bolded word: slightly. Do not bend them too much, or else it is difficult to trim the leads, causing a risk of a short.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
