Print PDF
Favorite
Email
Step 4WIre the LEDs
Remember the LM3916 switches negative not positive. So hook the positive up on all of your LEDS to positive in your breadboard.
Then pin 1 should go to the first pin on the LED, followed by pins 18-10 so they will light up in order.
As you can see in the second pic, I got a little sloppier on the second set of LEDs and just used wires from a jumper kit so its a little messy.
Then pin 1 should go to the first pin on the LED, followed by pins 18-10 so they will light up in order.
As you can see in the second pic, I got a little sloppier on the second set of LEDs and just used wires from a jumper kit so its a little messy.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
