Lanyard for a Surefire or similar flashlight

Picture of Lanyard for a Surefire or similar flashlight
When I got my Surefire from ebay, i was very happy with this tool of illumination, though not very happy with the price of its equipment.
So i thought about some ways of not spending all my money on gimmicks but using my brain first.

Look at what happened!

Remove these adsRemove these ads by Signing Up

Step 1: What you need:

Picture of What you need:
- a Surefire or similar lamp
- some weldingg wire
- some (combination) pliers (not in this Picture)

Remove tailcap and batteries.

Step 2: Step 2

Picture of Step 2
Bend the wire around the lower part of the lamp, below the rubber gasket or grommet-thing.

Step 3: Step 3

Picture of Step 3
Bend one end about 90 degree and cut the other one off, so that it looks like shown in the picture below.
Now you may need the pliers or at least a multitool.

Step 4: Step 4

Picture of Step 4
You can now remove the ring and blacken it with a lighter or paint it the color of your lamp.

When done, attach it to the lamp again and adjust it, so that it fits tight!
depending on you're lamp and the diameter of your wire you may need to flatten the ring with a hammer, in order to turn the lamps permanent light mode on.

Step 5: Step 5

Picture of Step 5
Take some paracord, cordstoppers and two nice knots and you have a nice and cheap lanyard, looking quite the same as the ones you get at the Surefire website.
You can also leave out the stoppers and only knot away, mabey with some monkeyfist at the end...

Attach it to the ring on the lamp, as shown below.
Yout might need the help of the plier again!

Step 6: DONE!

Picture of DONE!
Thats it, a nice and easy to handle lamp always at hand and unlosable, too!

Have FUN!