Print PDF
Favorite
Email
Step 2Making the Pattern and Cutting the Brackets
I traced one of the shelf brackets onto a piece of sturdy paper, cut it out, and used it to and then cut one end down until I arrived at the right height. for the stand.
From there it's pretty straightforward. Mark each bracket and cut.
Trim any extra bits away and sand off any rough edges.
From there it's pretty straightforward. Mark each bracket and cut.
Trim any extra bits away and sand off any rough edges.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
Sep 2, 2009. 3:07 AMDa_huuudge
says:
Fab. This has inspired me, I bet there are loads of things you could make re-appropriating Ikea bits. Did you think about adding a second handle to stop the stand snow ploughing?
Reply
 |
Add Comment
|
