Introduction: Laser Cut Guitar Stand for 3/4 Guitar

Picture of Laser Cut Guitar Stand for 3/4 Guitar

My daughter needed a guitar stand for her 3/4 size guitar. I had some 6mm baltic birch and a laser cutter. Just five pieces and a lot of wooden stars to boot. No glue, no paint. Just comes together with a little pressure. I've attached the DXF files for those interested. It's a metric DXF file. Guitar depth is 90mm or 3.5 inches. Guitar width is 10 inches.


These stars are so cute! I'm tempted to scale this down and make one for my violin!

audreyobscura (author)2013-10-10

ADORABLE! This came out great!

About This Instructable




More by p3nguin:TARDISDesign your own reference bookshelf speakersLaser Crown
Add instructable to: