Print PDF
Favorite
Email
Step 5Launch It!
Time to be honest - things did not go as well as expected.
The hovercraft worked, but the large hole in the cap meant that it only ran for a couple of seconds.
Restricting the air-flow seemed to cure this, but I left things a bit late to finish this Instructable, and did not wait until the glue dried before testing. (Bad Kiteman, naughty Kiteman!)
This meant that the glue oozed through the paper and stuck to the mat while I was holding the hovercraft still.
Have a look at the video to see the results so far, but the deadline is too close to be able to try it with a dry, non-adhesive base.
The hovercraft worked, but the large hole in the cap meant that it only ran for a couple of seconds.
Restricting the air-flow seemed to cure this, but I left things a bit late to finish this Instructable, and did not wait until the glue dried before testing. (Bad Kiteman, naughty Kiteman!)
This meant that the glue oozed through the paper and stuck to the mat while I was holding the hovercraft still.
Have a look at the video to see the results so far, but the deadline is too close to be able to try it with a dry, non-adhesive base.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
6
Dec 11, 2008. 4:14 PM
Kryptonite
says:
Kryptonite
says:
I've tried this the "Original" way, and I think it worked better than yours, any ideas why? I thought that yours would go better, oh well, better luck next time.
Reply
 |
Add Comment
|
