Step 5: Cutting the Panels
I went to the lumber yard and bought three half-sheets of 3/4" MDF. (I know from experience that I can neither lift nor haul full sheets, so I buy half or quarter sheets whenever I can.)
I don't own a table saw, so I wrote up a cut plan and used a circular saw with a fresh carbide blade, a tape measure, a big L-square and one of those nice clamp-on straightedges from Rockler. My panels actually turned out more square than the last couple of times I've cut big panels on a table saw.
I don't own a table saw, so I wrote up a cut plan and used a circular saw with a fresh carbide blade, a tape measure, a big L-square and one of those nice clamp-on straightedges from Rockler. My panels actually turned out more square than the last couple of times I've cut big panels on a table saw.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
Visit Our Store »
Go Pro Today »
