Print PDF
Favorite
Email
Step 7Hardware and assembly
Now for assembly. Track down all that hardware you laid out earlier. Triple check the positioning. Using the tools intended for the hardware, have at it. As with tooling, square, even, firm blows are optimum. A firm surface for setting is a good idea too. Firm means floor, not kitchen table. I got the multi tool set that has one anvil for all the rivet and snap sizes. Very handy, if you plan on doing any more of this type of stuff, I highly recommend obtaining it.
Technically, the watch is complete but DONT TOUCH THAT REMOTE!! Next up is leather bracelets + further means of tooling and decorating leather.
Technically, the watch is complete but DONT TOUCH THAT REMOTE!! Next up is leather bracelets + further means of tooling and decorating leather.
| « Previous Step | Download PDFView All Steps | Next Step » |
1
comment
|
Add Comment
|
Feb 8, 2012. 9:02 PMravenhaker
says:
Where did you get that watch and about how much was it?
Reply
 |
Add Comment
|
