Print PDF
Favorite
Email
Step 6Measure and mark along the center line
In this step, you will make tick marks along the center line for each section in the design.
Start off by placing a tick mark where the mouthpiece is going to be.
Then measure along the center line from the mouthpiece, the distance to the next section of the bore design and make another tick mark.
For this didge, the second section is .628m away from the mouthpiece, so I'll take the yard stick and measure the appropriate distance and make another tick mark.
Do this for each remaining section.
Start off by placing a tick mark where the mouthpiece is going to be.
Then measure along the center line from the mouthpiece, the distance to the next section of the bore design and make another tick mark.
For this didge, the second section is .628m away from the mouthpiece, so I'll take the yard stick and measure the appropriate distance and make another tick mark.
Do this for each remaining section.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
