Given that I drove the same car for over 10 years, certain parts are getting a little worn around the edges. For instance, my shift boot is a piece of vinyl. It's been coming apart at the seams and started to get annoyingly stiff up around the neck. I've started to look for replacement leather shift boots, and as expected found tons of them all over the Internet. I picked out ones that specifically claimed to fit my car, but then it occurred to me that it may not fit right. I don't use the OEM shift knob and the original boot never cinched at the neck right for my shift knob anyway. So a pre-made shift boot may fit well to not too good ugly. Given that most likely, I'll need to modify ones that are premade, why not just sew one together myself. Just need to cut and stick together 4 pieces of material. How hard could it be?
Well, that single question to myself started this whole leather thing, and I eventually ended up with a leather wrapped shift knob and steering wheel in addition to the original project, the shift boot. I have never thought about a leather steering wheel, and my plastic wheel was just fine, however most cars today at least have leather as an option for the steering wheel. So figure why the hell not.
Unfortunately, I didn't take any pictures while doing the boot and shift knob, but those where easy compared to putting together the steering wheel.