Introduction: Led Blinking Project.

Picture of Led Blinking Project.

This is a simple led blinking project. That blink one by one

Step 1: Apparatus Requirements

Picture of Apparatus Requirements

Bring arduino uno r3 development board or any as per ur choice but i am using that board and some led(5pcs)

Step 2: Connection Diagram

Picture of Connection Diagram

Connect led as per diagram.

*note long strip of led is positive/plus(+) and small strip is for negative/minus/ground (-)

Step 3: Programming

Picture of Programming

//Download arduino sketch application from official websitethen install and open it after that paste this code

int led=13;
int led2=11; int led3=10; int led4=9; int led5=8; void setup() { // put your setup code here, to run once: pinMode(led,OUTPUT); pinMode(led2,OUTPUT); pinMode(led3,OUTPUT); pinMode(led4,OUTPUT); pinMode(led5,OUTPUT); }

void loop() { digitalWrite(led,HIGH); delay(50); digitalWrite(led2,HIGH); delay(50); digitalWrite(led3,HIGH); delay(50); digitalWrite(led4,HIGH); delay(50); digitalWrite(led5,HIGH); delay(50); digitalWrite(led,LOW); delay(50); digitalWrite(led2,LOW); delay(50); digitalWrite(led3,LOW); delay(50); digitalWrite(led4,LOW); delay(50); digitalWrite(led5,LOW); delay(50); // put your main code here, to run repeatedly:

}

Step 4: Final Step

Picture of Final Step

Verify and upload your program in the arduino board, u have done

Step 5:

Comments

purushottamd3 (author)2016-09-19

https://m.youtube.com/watch?v=iudNEVF-8ew

Swansong (author)2016-09-19

Thanks for sharing :)

About This Instructable

113views

0favorites

License:

Bio: i am a student of Electrical engineering
More by purushottamd3:Led Blinking Project.
Add instructable to: