Led Candles Moodlight

Step 1 Parts and materials

You need these parts and materials:

- slow flash color leds (browse ebay with these keywords), I used 3 of 5mm type

- moderately large votive candles, 3 as above, 6cm or higher and 6cm in diameter

- a base platter (wood, ceramic, metal ... I used a square piece of plywood, just too small, damn ... a plain porcelain dish would works great)

- a wall wart power supply (I used a 12V/100mA one, but every type from 5V upto 15V works)

- a female connector that match the power supply output connector (barrel, jack etc)

- a 5V/1A regulator IC(classic 7805 or so)

- a 100uF/16V electrolytic capacitor

- some insulated copper wires (short pieces from net cables work well)

- electrical tape or heat shrinking tube (2-3 mm type)