Introduction: Lego Car Plane

Here is a list of step by step instructions on how to build your very own Lego car plane.

Step 1: Step 1

Start by setting the large flat gray piece down. Then place the 2  red 1X3 blocks at one end overhanging by one space. Butt the 2 white 2X6 blocks up to those. Butt the 2 yellow 2X4 blocks up to the white blocks. Now place the wheels underneath right next to the large gray piece.

Step 2: Step 2

Place the flat 2X2 black piece in center of yellow blocks as shown in picture. Then butt the flat yellow 2X4 plate up to the black one.

Step 3: Step 3

Place both of the red 2X10 plates on the white bricks right next to the yellow plate.

Step 4: Step 4

Place both white 1X8 blocks in between the red blocks. Then place yellow 2X6 block on top up against the red wings as seen in the picture.

Step 5: Step 5

Place white 2X8 block on top up against the yellow block. Then 3 steps back, place the blue 2X8 block on top. On top of that, put blue 2X4 block 3 steps back. Finally put the white 1X2 block on top at the end.

Step 6: Step 6

Place the sloped clear blocks on top as seen in the picture. Now you're finished!

Comments

About This Instructable

1,528views

1favorite

License:

More by xxmasimoxx:How to remove the engine from a '96 CamaroLego Car Plane
Add instructable to: