Step 1: CD Rack
1: Make two 18x18 layers of flat plates.
2: Make this with blocks of 3 in height and 1 in width.
3: Add another layer on it, with flat plates with 1 in height and 1 in width.
4: Add plates of 1 in height and 2 in width like this.
5: Repeat this as many times as many CD's you want it to hold. End with a block layer, not a 2-width-plate layer.
6: Place two flat layers on top.
7: Insert CD's.
Step 2: Tape Dispenser
1: Lie down flat 1-width-plates like this
2: Add a layer of 3-in-heights.
3: And another layer.
4: Make this.
5: A stave with 5 in length, two middle gears and flat wheel things.
6: Tape fit around that. Also lace blocks with a hole in it on both sides.
7: Put it in place and add a flat 1x6 plate on both sides.
8: Make this.
9: Add it to the thing, and also the other things you see.
Step 3: Cup Mat
1: You can only make this if you have a lot of these, with two different colors.
2: Make a spiral of four of them.
3: Make a lot of those and make a big square of it.
4: Add flatties on the sides.
5: Put a cup on it.
Step 4: Ball Pen
1: You need these things.
2: Make the top.
3: add so much cilinders that the thickening on the pen sticks to it.
4: Add more from the other side and a cone.