Introduction: Lego Light Up Spacecraft

Picture of Lego Light Up Spacecraft

This spacecraft is built with a light on it for not getting lost in "deep space".

Step 1: Parts

Picture of Parts

The parts you need are for the most part very basic

Step 2: Cockpit

Picture of Cockpit

First take the 2 T shaped platforms and put them together than add nose.add a Control board.add back of seat and the cockpit is finished

Step 3: Engine

Picture of Engine

4pieces

Step 4: The Dish

Picture of The Dish

The colorful dish has a few transparent colored parts

Step 5: Dish Base

Picture of Dish Base

The dish clicks into the center of this piece

Step 6: Lower Body

Picture of Lower Body

Now we add on to the cockpit

Step 7: Light

Picture of Light

At this time we will add the light because this ship is built around the light to secure it. Start with a fake candle ,Open the battery cover, Pry it out, Close the battery covernow it should fit height wise,but it doesn't side to side.trim each side with scissors.now it fits but there's slide room put one more lego in to secure itleave the switch sticking out a little so you can turn it on and off when you close the body

Step 8: Upper Body

Picture of Upper Body

Now we will enclose the light with the upper body and attach the rear wheels.NOTE:does not roll.

Comments

seamster (author)2014-11-20

Cool! That's a great idea to use an electric tea light like that. Nicely done!

About This Instructable

232views

1favorite

License:

More by BrianA1:Crayon Melt ArtLego Light up Spacecraft
Add instructable to: