The finished product, the second image shows the original case for the memory stick and the final image shows the LED in action. I was tempted to mak...
Creating a case out of Lego to house a USB memory stick. This has been done before but I haven't seen it done like this :)
Step 1: Creating The Case
Because my memory stick was quite large (in dimensions, not in storage capacity) I had to create a 6x3 Lego brick. I chopped a 4x2 and a 2x2 brick in half using a pen knife and another brick as a guide, the pliers on the same penknife were then used to remove the inner bits of the bricks and then the knife was used once again to remove the sides. Another 4x2 and a 2x2 brick were then used to create the case.
The four parts were stuck together using super glue and a steady hand.