Print PDF
Favorite
Email
Step 2Installing the stick
A groove was cut into the case to locate the USB connector and after a small amount of modification to the PCB the stick was installed.
| « Previous Step | Download PDFView All Steps | Next Step » |
7
comments
|
Add Comment
|
Feb 23, 2011. 5:51 PMwickedsonic1
says:
cool, nice but i think its un nessecary to modify the body of the flash drive, instead cut the groove in the brick dont further to position the full body then fill up the bottom with ABS plastic and then put a base on it
Reply
Jan 21, 2011. 10:38 PMkazandra
says:
hmmm gagawin ko rin yan hehehe i like it hehhehe
Reply
Jun 15, 2009. 7:57 PMalphasquad1234
says:
PCB? sry im a serious nub
Reply
21
Jun 18, 2009. 5:06 PM
zack247
says:
zack247
says:
Printed Circuit Board: PCB
Reply
Jun 4, 2009. 9:10 PMyoshie15
says:
i actually wouldnt mind making something like tat
Reply
Jan 12, 2009. 6:47 AMdarkbro999
says:
well, i've wanted to know, how big(in storage)is your flashdrive
Reply
Jan 12, 2009. 6:48 AMdarkbro999
says:
o yea, very nice 'ible, ill definitely try this one out
Reply
Jan 11, 2009. 7:59 PMdaisuke0615
says:
It's very nice. I'll try it.
Reply
 |
Add Comment
|
