Step 6: A reflector
I made a simple reflector to direct the huge amounts of dazzling light emitted from this device. It's made from paper covered in foil formed in a cone shape. I drew and cut out a paper circle around 80mm diameter, and cut the same out of aluminium foil. Tape the two together.
Then cut a straight line to the centre, and a cut a small 1cm circle out of the centre. You can roll it around now, like one of those protective collars vets give to animals to stop them injuring themselves even more. Tape the cone together at desired shape.
The reflector is attached to the wood using a small piece of cardboard that has and angle cut at the same angle as the reflector. This is taped to the reflector and to the wood.
Then cut a straight line to the centre, and a cut a small 1cm circle out of the centre. You can roll it around now, like one of those protective collars vets give to animals to stop them injuring themselves even more. Tape the cone together at desired shape.
The reflector is attached to the wood using a small piece of cardboard that has and angle cut at the same angle as the reflector. This is taped to the reflector and to the wood.
Remove these ads by
Signing UpFlag this comment as:
Not NiceInappropriateSpam
Visit Our Store »
Go Pro Today »
