Print PDF
Favorite
Email
Step 3Cutting Rods
Cut out two 3 inch rods, and another 3 inch piece with a bend in the end.
My rod had a bend in it already, but you can make one by clamping the rod in a vice and pushing on it, until it bends 90 degrees.
To cut the rods, secure them in a vice, and use a hacksaw to make cuts.
Smooth the ends using a piece of sandpaper.
My rod had a bend in it already, but you can make one by clamping the rod in a vice and pushing on it, until it bends 90 degrees.
To cut the rods, secure them in a vice, and use a hacksaw to make cuts.
Smooth the ends using a piece of sandpaper.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
