Print PDF
Favorite
Email
Step 4Programming the C Stamp
After the building the program, you are now ready to program your C Stamp.
Open the CSTAMP(TM) Quick Programmer. You will be presented with the following program.
To program the C Stamp, follow these steps.
1) Select your COM Port and Refresh.
2) Open the HEX File that you wish to use. (This will be in the same directory as the workspace you built in MPLAB.)
3) Connect to your C Stamp.
4) Write Device
After completing the previous steps and waiting for the program to finish writing, it should say "WRITING COMPLETE" where it says "WRITE STATUS".
Congratulations! You should now have an LED that flashes every second.
For more information on the C Stamp visit http://www.c-stamp.com
Open the CSTAMP(TM) Quick Programmer. You will be presented with the following program.
To program the C Stamp, follow these steps.
1) Select your COM Port and Refresh.
2) Open the HEX File that you wish to use. (This will be in the same directory as the workspace you built in MPLAB.)
3) Connect to your C Stamp.
4) Write Device
After completing the previous steps and waiting for the program to finish writing, it should say "WRITING COMPLETE" where it says "WRITE STATUS".
Congratulations! You should now have an LED that flashes every second.
For more information on the C Stamp visit http://www.c-stamp.com
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
