Introduction: LinkIt One + Touch Sensor

Picture of LinkIt One + Touch Sensor

In this project I will be demonstrating how to use a Touch Sensor with a LinkIt one Board

Step 1: Connect Sensor and Calabrate

Picture of Connect Sensor and Calabrate

Use the POT to calibrate the sensor until the light if off unless you touch the sensor

Step 2: Upload Code

Picture of Upload Code

If you dont know how to install LinkIt One code click here

this is the code I made for this project:

-------------------------------------------------------------------->

//Code Created By FunguyPro www.funguypro.tk

#defineARDUINO150

//#define BLYNK_PRINT Serial //Uncomment for Serial Data

#include<LWiFi.h>

#include<LWiFiClient.h>

#include<BlynkSimpleLinkItONE.h>

// You should get Auth Token in the Blynk App.

// Go to the Project Settings (nut icon).

charauth[]="YOURAUTHCODE";

#defineWIFI_SSID"YOURSSID"// Your network SSID (name)

#defineWIFI_PASS"YOURPASS"// Your network password (use for WPA, or use as key for WEP)

#defineWIFI_AUTHLWIFI_WPA// choose from LWIFI_OPEN, LWIFI_WPA, or LWIFI_WEP


voidsetup(){

Serial.begin(9600);

Blynk.begin(auth,WIFI_SSID,WIFI_PASS,WIFI_AUTH);

delay(500);}

voidloop(){

Blynk.run();

}

Step 3: Install Blynk and Run

Picture of Install Blynk and Run

Don't Know How? Click Here

Step 4: Need Help?

Click Here

Comments

About This Instructable

265views

8favorites

License:

Bio: I like to create new things! I'm very interested in IOT and just Internet Stuff. I am not responsible for any injury or deaths ... More »
More by Funguypro:3D Print Your House!!!!!DIY Raspberry Pi Indoor Outdoor WebcamSee Through Buildings With a Drone
Add instructable to: