Print PDF
Favorite
Email
Step 2Dissassemble the Cheapo Bike Flasher
1. Pry off the lens, or as in my case, just turn the light over and it will fall off.
2. Unscrew the one screw holding the PCB down to the plastic housing.
3. The power and switch contacts on the back of the PCB are not soldered on, they are just touching. Take note as to where the positive, negative, and switch terminals are. You will need to solder wires to each one of these points.
2. Unscrew the one screw holding the PCB down to the plastic housing.
3. The power and switch contacts on the back of the PCB are not soldered on, they are just touching. Take note as to where the positive, negative, and switch terminals are. You will need to solder wires to each one of these points.
| « Previous Step | Download PDFView All Steps | Next Step » |
 |
Add Comment
|
