With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
The following instructions will allow you to build a practical test tool for troubleshooting and analyzing digital and microcontroller circuits. The complete Assembly and Instruction Manual can be ...
Here's the components needed to build the Logic Probe shown in the Bill of Materials (BOM) picture.
Here's the circuit schematic diagram for the Logic Probe.
Add the 1K and 330/470 ohm resistors onto the pcb and solder.
Place the (2) 150nf (0.15uF) capacitors onto the pcb and solder.
Add a 5V Voltage Regulator IC, (2) 14 Pin DIP sockets, the Hex Inverter IC and the 7 Segment LED display components onto the pcb and solder them.
Snap a 9V Battery to the battery clip. The Letter L should be displayed on the 7 Segment LED Display. Next soldered a red wire on the pcb ...
Three tool electronics kit.by Computothought
Troubleshoot your car battery with ATtiny.by rlarios
Edison IOT Ignition interrupt deviceby joshualeelaird
Discover Electronics With Snap Circuits Arcade (A Review)by KRA5H
Building a Digital Oscilloscope from a DIY Kitby Josehf Murchison
Join 2 million + to receive instant DIY inspiration in your inbox.
Download our apps!
© 2016 Autodesk, Inc.