With Instructables you can share what you make with the world and tap into an ever-growing community of creative experts.
Where to put an on/off switch for the batteries of the Logi' MX900 optical mouse? My battered mouse.
If your like me & you have piles of junk never thrown out this may be eaisier? (I'll make it clear later on!) 1.small Philips screwdriver 2.solder ir...
Flip it over & take out the batt's that drain when left in/on. The 2 screws that hold the top onto the base are located in the batt compartment & at t...
Looking from above the mouse the 2 terminals for the batt's are near to the back. These are where the switch is to be placed in between to create the ...
Got this switch out of an old bit of electronics left as junk. Nice & small/thin.
The - terminal was de-soldered & the spring connecting contact slides out. Now I got another springy contact from some other junk of an old TV rem...
Put the springy - terminal back into the compartment with the end facing toward the hole that is made in the base for the switch. Hold on! THE HOLE FO...
Solder 2 pieces of wire form the terminals of the switch (after testing to make sure they are the make & not make terminals) then solder one of them t...
It fitted nicely without any bulge to complain about & the slight unsightliness is unseen any way really but can be given a bit of a spruce with an ex...
Remove these ads by
Signing Up
Not NiceInappropriateSpam
PDF Downloads
As a Pro member, you will gain access to download any Instructable in the PDF format.
You also have the ability to customize your PDF download.
Visit Our Store »
Go Pro Today »